Nokia CC100 - Manual (Page 48)

CC100 Master Bridge User’s Guide
45
[ -c ] addresses can be setup, refer Static MAC
: max 8 entries
: bind the current MAC entry to LAN1 or LAN2 port,
i.e. enable this MAC entry as static MAC
:disable this MAC entry, neither bind to LAN1 nor LAN2
: remove the current MAC entry, invalid this MAC entry to
default 00-00-00-00-00-00
swtagvlan
[ -c ]
[ -p
[ -r ]
[ -v ]
[ -i ]
[ -o
tag/
bypass >]]
Display or set up the LAN1/LAN2/HCNA Tag VLAN. refer Tag
VLAN Setup for more.
: configure LAN1 or LAN2 or HCNA port
: 802.1p value, 0~7
: 802.1Q VID, 0~4096
: ingress rule -- accept all incoming packets or accept
incoming tagged packets only, reject other incoming packets.
: egress rule: un-tag or tag or bypass the
outgoing packet
-c: enable Tag VLAN mode or not
-p: the port in Tag VLAN mode
-r: 802.1p in Tag VLAN mode
-v: VID of 802.1Q in Tag VLAN mode
-I: ingress rule for the port in Tag VLAN mode
-o: egress rule for the port in Tag VLAN mod
tftp
-s
-c
-f
Run TFTP client to get file (upload file onto CC100) or to put
file (retrieve file from CC100) from TFTP server IP
.
: run TFTP command ‘ get ’ or ‘ put ’
: filename
time
Display current System Time.
upep
[ -a ]
[ -m ]
[ -n ]
Upgrade EP HCNA driver (stored in Upload Area), this
operation also synchronize EP with EP
Properties Profile
stored in CC100,
-a: upgrade all on-line EP at once
-m: upgrade the EP with matched MAC
-n: upgrade (matched MAC ) EP ‘Note’ property
upmaster
Upgrade Master HCNA driver (stored in Upload Area), this
operation also synchronize Master HCNA device with its setting
values in
Properties Profile .
upsys
Upgrade the uploaded system firmware (stored in Upload
Area), then reboot.
useradd
name
-p
-r
Create new management user account.
name: user name
-p: login password
-r: ‘
ro ’ for user has read-only privilege, ‘ rw ’ for user has read-
write privilege
userdel
name Delete the management user account by name.
name: user name
users Display all user accounts.