Nuvo NV-E6XS - Manual (Page 12)

1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
1 2 3 4 5 6 7 8 O
N
Page 10
The single most important aspect of the installation
is to address the keypads correctly. The DIP switches
labeled 1-4 are used to set the address (zone #) that
this particular keypad will control.
On the back of the keypad is a chart that indicates
how to set these switches (Fig. 7). To set the keypad
to control zone #1, set switch #1 down (1) and switches
2-4 up (0). This keypad will now control the speakers
that are plugged into the “Zone 1” speaker outputs
(Fig. 8).
Plug the keypad into the Cat-5 cable that is in zone
#1. If you press the “ON/OFF” button, the keypad
should light up and the LED on the front panel of the
E6M amplifier for “ZONE 1” should light up.
Fig. 8: DIP switches 1-4
Zone 1 Zone 2
1 2 3 4 5 6 7 8 O
N
Zone 3 Zone 4
Zone 5
Zone 7
Zone 6
Zone 8
Zone 9 Zone 10
Zone 11 Zone 12
The three addresses labeled ZN 1*, 2*, and 3* are
set aside so that two keypads can be used in zones
1, 2, and 3. For instance, zone 1 can have two keypads:
one addressed 1-0-0-0 and one addressed 1-0-1-1
(Fig. 9). This allows for a total of 15 keypads in a 12-
zoned system.
Fig. 9: Zone 1, 2, and 3 additional
keypads
1 2 3 4 5 6 7 8 O
N
Zone 3*
Zone 2* Zone 1*
1 2 3 4 5 6 7 8 O
N
VIII. Setting the NV-EKP DIP Switches