NordicTrack NTC07940 - Manual (Page 6)

6
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 40mm Button Screws (54) and four M8 Split
Washers (55).
3
2
1
78
43
88
97
99
99
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (97) to
the Lower Wire Harness (43). Gently pull the upper
end of the Upper Wire Harness to remove any slack
from the Wire Harnesses.
Insert the Upright (2) into the Frame (1). Be careful to
avoid pinching the Wire Harnesses (43, 97). Attach
the Upright with two M10 x 118mm Button Screws (78),
two M10 Split Washers (88), and two Upright Spacers
(99).
Make sure the concave end of each Upright
Spacer is turned toward the Upright.
4. Identify the Left Handlebar (70), which is marked with
an “L” sticker. Hold the Left Handlebar near the Upright
(2). Connect the left Pulse Sensor Wire (6) to the
Pulse Wire (3).
Slide the Left Handlebar (70) onto the indicated tube
on the Upright (2).
Be careful to avoid pinching the
left Pulse Sensor Wire (6) or the Pulse Wire (3).
Carefully insert two M8 x 40mm Button Bolts (81)
through the Left Handlebar and the tube on the
Upright.
Be careful not to damage the Wires with
the Button Bolts. Tighten the two Button Bolts into
two M8 Nylon Locknuts (89).
Make sure the Nylon
Locknuts are seated in the hexagonal holes in the
Left Handlebar.
Attach the Right Handlebar (72) in the same way.
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
16
1
55
55
54
54
2
4
Tube
89
3
2
6
70
72
Make sure the wires
do not get damaged
during this step.
81