NordicTrack NTC07940 - Manual (Page 5)

5
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench .
Use the drawings below to identify the small parts used during assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on page 25. The number following the key number is
the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled.
M10 Nylon
Locknut (63)–2
M8 Split
Washer (55)–12
M10 Split
Washer (88)–2
M6 Washer
(60)–5
M10 x 118mm Button Screw (78)–2
M10 x 52mm Button Bolt (82)–2
M8 x 40mm Button
Screw (54)–8
M8 x 25mm Button
Screw (79)–4
M4 x 16mm
Screw (57)–4
M6 x 45mm Button
Screw (80)–1
M8 Nylon
Locknut (89)–4
M8 x 40mm Button
Bolt (81)–4
M6 x 20mm Button
Screw (20)–6
1. Identify the Front Stabilizer (15). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with four M8 x 40mm Button
Screws (54) and four M8 Split Washers (55).
15
1
55
55
54
54
1