NetComm 56K WebMaster CD1800 - Manual (Page 5)

Rev.2 - YML664 www.netcomm.com.au
CD1800 56K WebMaster Quick Start Guide Page 5
Step 2 - Software Installation
Windows® XP
1. Once your Computer has started and you
have connected your modem correctly
you will be presented with a message
saying "New Hardware Found" and the
"Found New Hardware Wizard" is
displayed. Select "Install the software
automatically [Recommended]", and then
click "Next" .
Note: Windows XP may have generic
drivers that install automatically
on start-up. If this is the case
these drivers can be used,
however if you wish to use the
NetComm drivers please
continue with the following
installation steps.
2. The drivers that Windows XP uses are
not digitally signed by Microsoft and the
following message will be displayed. Click
"Continue Anyway".
3. Windows XP will locate all available
driver files for your modem. Select one of
the drivers and click on "Next" to
continue.
4. Windows XP will now copy the required
files. Once all files have been copied, click
"Finish", and the installation is complete.
6. To verify installation a message will be
displayed on your bottom task bar stating
"Found New Hardware, your new
hardware is installed and ready to use".