Eizo T566 - Manual (Page 12)

English
12
2. INSTALLATION
2-2. Getting Ready for Operation
Try each setting procedure if necessary in the following cases.
The display image size and/or position is not appropriate.
→ Press the AUTO/FINE MODE button on the front panel for more
than 2 seconds.
The AUTO-SIZING function centers the displayed image, aligning the image's
borders with respect to the monitor frame. In general, press the AUTO/FINE
MODE button whenever changing the graphics card or the resolution (p. 31), or
when image size and/or position is incorrect.
NOTE
• Pushing the AUTO/FINE MODE button lightly allows changing of the Fine
Contrast mode.
The display area is too large or too small.
→ Readjust the refresh rates.
Readjust the preferred refresh rates in accordance with the following look-up-table.
Refer to the PC or graphics card manuals on how to change the refresh rates.
[The maximum (non-interlaced) vertical refresh rates for the model]
Maximum Vertical Refresh rate (Hz) Horizontal
frequency (kHz)
640Ч480 800Ч600 1024Ч768 1280Ч1024 1600Ч1200
30-96 160 144 118 89 76
NOTE
• About Plug & Play of the monitor
When your computer and monitor support VESA DDC, the suitable resolution
and the refresh rate are set by just plugging your monitor into the computer
without any manual settings. When your computer system supports Plug &
Play, the Display Information File is not required except for installing the Color
Profile.
Further adjustment is required
→ Adjust the screen using the ScreenManager. (See page 13.)