NCR S10XL User Manual
Page 129
Sample Configurations
Sample Standard Configuration
NCR S10XL Hot Plug Server User Guide
C-9
4.
Select SCSI Device Configuration and set the
parameters as follows:
SCSI Device ID (tab to desired device)
Initiate Sync Negotiation
[yes]
Maximum Sync Transfer Rate
[20]
Enable Disconnection
[yes]
Initiate Wide Negotiation
[yes]
Send Start Unit Command
[yes]
5.
Press [Enter] to return to previous menu.
6.
Select Advanced Configuration Options and set the
parameters as follows:
Host Adapter BIOS (Config Util...)
[Enabled]
Support Removable Disks...
[Boot Only]
Extended BIOS Translation...
[Enabled]
Display
BIOS Initialization...
[Enabled]
Multiple LUN Support
[Disabled]
BIOS Support for More than 2...
[Enabled]
7.
Press [Enter] to return to previous menu.
8.
Press [Esc] until prompted to save configuration.
Save the configuration and the system reboots.
Sometimes the EISA Configuration Utility will not boot.
If this happens, perform the following procedure:
1.
Using the BIOS Setup Utility, disable all PCI
adapters.
2.
Boot the EISA Configuration Utility.
Configuring the
Memory and Other
Baseboard Settings