NuTone NS Series - Manual (Page 4)

models Ns130Bl • Ns130ss • Ns130WW
Ns136Bl • Ns136ss • Ns136WW
Page
10 ducted iNstallatioN oNlY:
Remove vertical or horizontal duct knockout. Attach 3¼”
x 10” damper/duct connector (if using 3¼” x 10” duct)
or 7” oval duct Plate ** (if using 7-inch round duct)
over the knockout opening.
KNOCKOUT
OPENINGS
3¼” x 10”
DAMPER /
DUCT
CONNECTOR
7” OVAL
DUCT PLATE **
6 NoN-ducted iNstallatioN oNlY:
Remove Recirculation Scroll Wall from inside the hood.
RECIRCULATION
SCROLL WALL
7 NoN-ducted iNstallatioN oNlY:
Depress the tabs on the Recirculation Cover and
push cover out through top of hood to remove it.
RECIRCULATION
COVER
TABS
▼
▼
8 NoN-ducted iNstallatioN oNlY:
Remove recirculation grille from plastic bag and snap
it into the opening in the top of the hood.
RECIRCULATION
GRILLE
9 NoN-ducted iNstallatioN oNlY:
Remove recirculation Plate and thumb screw from
plastic bag. Slide plate down onto recirculation grille
so that slots in plate fit into tabs on grille. Secure plate
with thumb screw.
RECIRCULATION
GRILLE
RECIRCULATION
PLATE
SLOTS & TABS
THUMB
SCREW
** Note that the 7-in. round duct will need to be squeezed into an
oval shape to connect to the 7-in. oval duct plate on the hood.