NuTone 668RP - Manual (Page 3)

Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in Canada, Rev. 5/06, Part No. 88581
MOUNTING REFLECTOR AND GRILLE
1. Refer to Figure 3. Place reflector in the opening in the
center of the grille. The notches in the reflector should fit
over the pegs on either side of the opening. Insert plug
from lamp socket into white receptacle on wiring
c o m p a r t m e n t .
2. Place 1" screw, provided, through the center hole in the
reflector and thread it into the hole in the mounting bracket
running across the housing. Tighten the screw just
enough to hold the grille firmly against the ceiling.
3. Install a 100 watt maximum, type A-19 light bulb.
4. Refer to Figure 4. Snap lens into position in center of
grille. To remove the lens for relamping, gently pry along
the side of the lens with a screwdriver to disengage the
snap in tabs while pulling down on the lens.
FIGURE 4
LENS