Controls and indicators – Nautique 220 User Manual
Page 92
4-17
Locked Mode
When the boat’s battery is first connected, the unit is in locked
mode. In this mode, only the horn, bilge pump, bilge blower and
code keys operate.
Unlocked Mode
Unlocked mode is entered after the user successfully enters the
user code, presses and releases the start key. When the code keys
are pressed, the system indicator light will turn ON while the key is
pressed. This indicates the key has actually been pressed. When the
system is unlocked, power is supplied to the boat and the system
indicator light will turn ON. At this point all keypad keys will
operate and actuating these keys will control the corresponding
boat functions. To put the unit back in Locked Mode, the user must
successfully enter the user code, then press the STOP key. This will
turn off the system indicator light and shut off power to all of the
accessories except the horn, bilge pump, bilge blower and code
keys.
Run Mode
Enter the Unlocked Mode.
Pressing and releasing the START key quickly will put the unit in
Run Mode. Power is supplied to the engine ignition, but the engine
will not crank and the ignition indicator light is turned ON. If the
start key is not pressed again within 15 minutes, the unit will exit
Run Mode by shutting off power to the ignition and re-enter the
Unlocked Mode. If the user presses and holds the START key,
power is supplied to the ignition and starter for as long as the user
presses the START key. All accessory keys will operate in this mode.
Pressing the STOP key will shut off the engine and the unit is then
put back in the Unlocked Mode.
After the engine starts, release the START key.
Controls and Indicators
DO NOT hold the START key for more than 30
seconds. The starter motor can be damaged.
CAUTION
Naut Air Sec 4.qxd 8/29/06 4:21 PM Page 17