Nautique 220 User Manual
Page 171
8-16
1. Remove the drain plug (D) located in the bottom cover (E),
opposite the oil strainer (F). Reinstall the drain plug after all
the oil has drained.
2. Disconnect the oil hose (G) from the strainer elbow (H), but do
not remove the elbow.
3. Unscrew the strainer from the elbow and clean the strainer.
•
If the strainer is cleaned with a solvent, allow the strainer to
dry before installing.
•
Reinstall the strainer onto the elbow, install the strainer and
elbow into the housing and reinstall the oil hose.
4. Remove the two magnetic screw plugs (I), located diagonally
opposite, on the housing.
•
Verify the plugs removed are magnetic by placing another
metallic object to the plugs. Remove only the magnetic
plugs.
•
Clean any debris from the plugs and reinstall them into the
holes they were removed from.
•
Refill the housing following Oil Level Inspection.
Dispose of used oil in an environmentally safe manner.
Section 8
Correct Craft, Inc.
Naut Air Sec 8.qxd 8/29/06 4:24 PM Page 8-16