NISSAN 2009 Cube - Manual (Page 13)

CLOCK SET/ADJUSTMENT
Ⅲ Press and hold the CLOCK button until the clock display starts to flash.
Ⅲ Press the SEEK/TRACK button to adjust the hours.
Ⅲ Press the TUNE/FF-REW/FOLDER button to adjust the minutes.
Ⅲ Press the CLOCK button again to exit the clock set mode.
Ⅲ If no adjustment is performed, the display will return to the regular clock display after 10
seconds.
VEHICLE INFORMATION DISPLAY
When the ignition switch is placed in the ON position, the
vehicle information display shows the following information:
Ⅲ Outside air temperature (if so equipped)
Ⅲ Continuously Variable Transmission (CVT) position in-
dicator (if so equipped)
Ⅲ Odometer/Instrument brightness control
Ⅲ Twin trip odometer/Trip computer
To display modes of the trip computer push the trip
button to highlight the desired mode. Press the trip
button for 1 second to reset the information in the
highlighted mode.
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (if so equipped)
Ⅲ The CVT does not produce a gear change
sensation like traditional automatic transmis-
sions.
Ⅲ R (Reverse) speed for CVT vehicles is limited to
15 MPH (25 km/h).
The transmission in your vehicle requires a special
fluid available only at your NISSAN dealer. No other
fluid will meet the exact requirements of the CVT.
OVERDRIVE (O/D) OFF SWITCH
Ⅲ Each time your vehicle is started, the CVT is
automatically “reset” to Overdrive on.
Ⅲ To turn Overdrive mode off, push the O/D OFF
switch . The light in the instrument panel will illuminate.
Ⅲ Use the Overdrive off mode when you need improved engine braking.
11