Napoleon Fireplaces GVF40P - Manual (Page 2)

2
W415-0319 / D / 08.03.05
Hood
Louvre Bracket
Hinge Screen
Louvre Installation & Removal
Heat Shield Stand Off Removal
Logo Placement
16-17 OPTIONS
Patented Catalytic Glass Door
Blower Installation
18-19 OPERATION / MAINTENANCE
Operating Instructions
Maintenance
Catalytic Tile Maintenance
Oxygen Depletion Sensor Pilot Cleaning
Pilot Flame Appearance
Venturi Adjustment
20-21 REPLACEMENTS
Ordering Replacement Parts
Replacement Parts
22-23 TROUBLE SHOOTING GUIDE
PG 3-4 INTRODUCTION
Warranty
General Instructions
General Information
Care of Glass Doors, Catalytic Tiles
& Plated Parts
5-12 INSTALLATION
Combustion and Ventilation Air Provisions
Determining Confined or Unconfined Space
Gas Installation
Framing Dimensions
Peninsula Installation Procedure
Open End Installation Procedure
See-Thru Installation Procedure
Island Installation Procedure
13-15 FINISHING
Log Placement
Glowing Embers
Charcoal Embers
Mantle Installation
Curtain Mesh
WARNING
• Under no circumstances should this heater be modified.
• Provide adequate ventilation and combustion air. Provide adequate accessibility clearance for
servicing and operating the heater. Never obstruct the front opening of the heater.
• If heater shuts off, do not re-light until you provide fresh air. If heater keeps shutting off, have it
serviced. Keep burner and control compartment clean.
• Do not burn wood or other materials in this heater.
• Adults and especially children should be alerted to the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition. Keep young children and animals away
when the fireplace is hot.
• Due to high temperatures, the heater should be located out of traffic and away from furniture and
draperies.
• Clothing or other flammable material should not be placed on or near the heater.
• Any safety screen or guard removed for servicing must be replaced prior to operating the heater.
• It is imperative that the control compartments, burners and circulating air passageways in the
heater are kept clean. The heater should be inspected before use and at least annually by a
qualified service person. More frequent cleaning may be required due to excessive lint from
carpeting, bedding material, etc. The heater area must be kept clear and free from combustible
materials, gasoline and other flammable vapours and liquids.
• Furniture or other objects must be kept a minimum of 4 feet away from the front of the fireplace.
• Do not use this heater if any part has been under water. Immediately call a qualified service
technician to inspect the heater and to replace any part of the control system and any gas con-
trol which has been under water.
• Do not allow fans to blow directly into the fireplace. Avoid any drafts that alter burner flame
patterns.
• Do not use a blower insert, heat exchanger insert or other accessory not approved for use with
this heater.
ANY CHANGE TO THIS HEATER OR ITS CONTROLS CAN BE DANGEROUS AND IS PROHIBITED.
NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN
TABLE of CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE