Network Instruments WAN Probe Kit - Manual (Page 31)

Installing the Interface Cards and Drivers 25
Digital T1/E1 TAP
Digital DS3/E3 TAP
Serial T1 TAP
HSSI TAP
TEST
LOOP
POWER
TO PROBE
NETWORK INTERFACE UNIT
INTERFACE SELECTOR
E1
T1 RJ
BANTAM
E1
T1 RJ
BANTAM
LOOP Should remain unlit for normal operation.
Leave setting
on RJ
position.
POWER light should be
lit whenever TAP is
cabled to Interface Card.
DTE
POWER
DCE
LOS
LOF
LOS
LOF
DSE
IN OUT IN OUT
Loss of Signal,
—unlit when the
given device
(DTE or DCE)
drops carrier.
Loss of Frame
—unlit when the
given device
(DTE or DCE)
drops a frame.
POWER light should be lit
whenever TAP is cabled to
Interface Card.
B
POWER
DTE
DCE
MODE
A B
ACTIVE OUTPUT
Link activity LEDs--both should be lit
for normal operation.
MODE
A B
Leave on
setting B.
POWER light should be lit
whenever TAP is cabled
to Interface Card.
B
POWER
T3 WAN MONITOR TAP MODULE
INTERLOCK
OUTPUT TO PROBE
Interlock LED--should be lit for
normal operation.
POWER light should be lit
whenever TAP is cabled
to Interface Card.