Porter-Cable FRP350 - Manual (Page 11)

11
CLEARING A JAMMED FASTENER
Disconnect tool from air supply.
1. Remove any remaining fasteners from the nailer.
A. Place finger in recess (A) Fig. 28, and depress lever to release follower
mechanism.
B. With follower release lever depressed (A) Fig. 28, slide follower all the
way to the front of the magazine.
C. Depress spring (B) Fig. 29, slide fasteners to the rear, and remove all
fasteners from magazine (see Fig. 19).
2. Use a pair of needle nose pliers and/or a flat screwdriver to free bent
fastener from back of nosepiece. If fastener cannot be removed as
described, it may be necessary to remove the magazine as follows:
A. Loosen knob (A) Fig. 30 and move magazine in slotted bracket (B).
B. Slide magazine back, off of nosepiece. See (B) Fig. 31.
C. After clearing bent fastener (A) Fig. 31, reverse above steps to
reassemble.
Fig. 30
Fig. 31
B
A
Fig. 29 A
B
Fig. 28
A
B