Philips AJ3915CD - Manual (Page 6)

CD playback
This CD clock radio can play only audio discs
including CD-R (CD-recordable), CD-RW
(CD-rewritable)
. Do not try to play a
MP3-CD, CD-ROM, CD-RW, CDI,VCD, DVD
or computer CD.
1 Press POWER to switch on from standby.
➜ The display lights up.
2 Select CD source by pushing
CD•RADIO•BUZZER
to CD.
➜ “CD” is displayed.
3 Lift the CD door to open.
4 Insert a CD with printed side facing up, and
close the CD door.
➜ Flashing ---- is displayed briefly, then total
CD track number.
5 Press
); to start playback.
6 To view CD track information, press
DISPLAY
.
➜ The current track number is displayed for
several seconds (See 3), then it will
switch back to clock display.
7 To adjust the sound, turn VOLUME.
8 To interrupt, press
);.To resume playback,
press
); again.
9 To stop playback, press
9.
10 To switch off CD playback and back
to standby, press POWER.
➜ The display lights off.
Selecting a different track
• Press
∞/ § once or repeatedly until the
desired track number appears on the display.
• In the stop position, press
); to start
playback.
➜ The selected track number appears briefly
on the display when you press
∞, § to
skip tracks, then it switches back to clock
display.
Finding a passage within a
track
1 During playback, press and hold down
∞ or §.
➜ The CD is played at high speed and low
volume.
2 Release
∞ or § when you recognize the
passage you want.
➜ Normal CD playback resumes.
Programming tracks
You may store up to 20 tracks in the desired
sequence for playback. If you like, store any
track more than once.
1 In the stop position, press PROG to enter
programming mode.
➜ PROG and1
10 01 1 are displayed, and 0 01 1 is
flashing, indicating the start of
programming (See 4).
2 Press
∞ or § to select desired track.
3 Press PROG to store the track.
➜ 2
20 00 0 is displayed, and 0 00 0 is flashing,
indicating the second program sequence is
available.
3 Repeat steps 2 to 3 to select and store all
desired tracks.
➜ If you attempt to store more than 20
tracks, no tracks can be stored.
4 Press
); to play the program.
➜ PROG is displayed.
To erase a program , select any of the
following.
– In stop position press PROG to enter pro-
gram mode and press
9;
– Open the CD door.
– Press POWER to standby;
– Select RADIO or BUZZER position.
CD Player