Philips AJ3915CD - Manual (Page 4)

Supplied accessory
Line-in cable (used for audio input connec-
tion)
Controls (see 1)
1 REPEAT ALARM – pushes to switch off
alarm for a 6-minute period
2 LCD Display – shows the clock/ alarm time
or CD/radio information
3 POWER
– switches the set on or to standby
– stops the active buzzer, radio or CD alarm
for 24 hours
– switches off the sleep timer
4 ALARM 1/ ALARM 2
– sets and activates alarm of ALARM 1
/ALARM 2
– stops the active buzzer, radio or CD alarm
for 24 hours
5 CLOCK – sets clock time
6 SHUF/REP – selects different CD play
modes: e.g. REPEAT or SHUFFLE
(random order)
7
∞/ §
– adjusts clock / alarm time
– skips CD tracks/ searches for a particular
passage
8
9 – stops CD playback
– erases a CD program
9
); – starts/ pauses CD playback
0 PROG – programs CD tracks
!
LIFT TO OPEN – lift here to open CD door
@ DISPLAY – displays CD tracks or radio
information
# AUX – 3.5mm audio input jack
$ TUNING – tunes to a radio station
% BAND – selects waveband: FM or MW
^ SLEEP
– switches on/off radio, CD for timer mode
– adjusts timer options for radio/CD playback
& VOLUME – adjusts sound level
* CD•RADIO•BUZZER
– selects CD or radio sound source
– selects CD radio, or buzzer or alarm mode
( Power cord – connects to wall outlet
) Pigtail – FM antenna to improve FM
reception
¡ Battery compartment – insert a 9 volt
battery, typed 6F22 (not supplied) for clock
memory backup
Power supply
1 Check if the power voltage as shown on the
type plate on the base of the set corresponds
to your local power supply. If it does not,
consult your dealer or service center.
2 Connect the power plug to the wall outlet.
The power supply is now switched on and
the numbers on the display shows 0:00.You
will need to set the correct time.
3 To disconnect the set from the power supply
completely, unplug from the wall outlet.
The type plate is located on the bottom
of the set.
English Controls Power supply