Polaris Trail Blazer 9922460 - Manual (Page 74)

70
MAINTENANCE
Camber and Caster
The camber and caster are non-adjustable.
Rear Spring
The rear shock absorber spring is
adjusted by rotating the adjuster either
clockwise or counterclockwise to
increase or decrease spring tension.
Accessory springs are available through
your Polaris dealer.
Handlebars
The handlebars can be adjusted for rider preference.
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your Polaris dealer for service.
1. Remove the handlebar cover to
access the handlebar bolts.
2. Loosen the four handlebar bolts.
3. Adjust the handlebar to the
desired height.
4. Be sure the handlebars do not
contact the gas tank or any other
part of the machine when turned
fully to the left or right.
5. Torque the front two bolts to 10-12 ft. lbs. (14-17 Nm), then torque
the rear two bolts. A gap of up to 1/8" (3 mm) will remain at the rear
bolts.
Adjuster
Handlebar Bolts