PYLE Audio PLPK65TVD - Manual (Page 44)

12
TROUBLE SHOOTING
The following checks will assist in the reaction of most problems which you may
counter with your unit. Should any problem persest after you have made these check,
consult your nearest service dealer.
Before going through the check list be first refer back to the connection operation
procedures
CAUTION
Metal parts of this unit (especially on
the back) become quite hot during
operation, to be careful to avoid
touching parts other than the handle
immediately after removing the unit.
Symptom Cause Solution
No power The car ignition switch is
not ON. If the power supply is connected
to the car accessory circuits, but
the engine is not moving, switch
the ignition key to "ACC".
The fuse is blown. Replace the fuse with another
fuse.
No Sound The power is not
connected properly. Double check the power line.
The connection lines are
not connected properly. Check the speaker wires and
other connection wires.
Cassette tape can
not be loaded or
ejected Presence of a cassette
tape in the player. Remove the cassette tape in the
player, then put in the new one.
The temperature in the car
is too high. Cool off the inside of the car,
then try again.
Condensation. Leave the cassette player off for
an hour or so then try again.
The sound quality
is poor. The cassette is defective. Try another cassette. If that
cassette plays properly, the first
cassette is defective.
The radio does not
work. The antenna cable is not
connected. Insert the antenna cable firmly.
The radio station
automatic selection
does not work. The signals are too weak. Select a station manually.