PAC SWI-RC - Manual (Page 5)

5
06-18-10
Programming the SWI-RC to Control the Head Unit (cont.)
SWI-RC
Once programming is
completed,
wait 7 seconds .
The LED will flash three times
indicating end of programming.
The Interface will then flash the
vehicle version number it was
programmed for.
Step G.
After all buttons are
programmed
Testing the SWI-RC
A. When testing the audio controls, the left LED on the
SWI-RC will flash indicating it is sending a command.
If any function does not work, repeat the programming
instructions (starting from Step 11) or refer to
Troubleshooting Guide.
VOL
Appendix A.
SWI-RC
SWI-RC
SWI-RC
SWI-RC
If you programmed the interface for version #4, proceed with the following steps.
If you did not program the interface for version #4, please disregard.
Step B.
Press and hold
programming/
mode button
on SWI-RC.
Step D.
Press and hold the TEMP UP
button on the steering wheel
control.
LED will turn off.
LED will light.
Step C.
Release
programming/
mode button.
Step E.
Release the TEMP UP button.
LED will turn on. The
function is pro-
grammed.
SWI-RC
TEMP
TEMP
SWI-RC
Step A.
Turn the vehicle ignition to
the ON position.
LED will flash 4 times
to indicate set version
number.
OFF
ACC
IGN
STRT
LED will turn
off