PAC SWI-RC - Manual (Page 3)

3
06-18-10
Step A.
Refer to The Vehicle Application Guide or www.pac-audio.com/swixprogramming/swixprogramming.asp for the proper version
number. Refer to the programming chart on page 4 for the proper radio select switch setting. Fill in the information below for
quick reference. Please note that it is very important to set the radio select switch before turning on the ignition
beginning programming.
Vehicle Version Number: ____________ Radio Select Switch: ____________
SWI-RC
Step 2 - Programming the Version #
Step B.
Press and hold programming/
mode button on SWI-RC. Turn the
vehicle ignition to the ON position
while still holding the button in.
The LED on the
SWI-RC will light.
Step C.
Release the programming/
mode button.
The LED will turn off,
indicating memory is
cleared.
Step D.
Press and release the program-
ming/mode button the same
number of times as the desired
version number.
The LED will flash
each time the button is
pressed and released.
Step E.
WAIT 3 seconds, the
LED will flash the same
amount of times as set
version number.
Step F.
Turn vehicle ignition
to OFF position.
Vehicle programming
sequence is complete.
SWI-RC
OFF
ACC
IGN
STRT
OFF
ACC
IGN
STRT
SWI-RC
SWI-RC
SWI-RC
SWI-RC
1
2 3 4 5
6
7 8 9
0
Radio Select Switch
located on the side of
SWI-RC interface
SWI-RC