Pioneer AVD-W6010 - Manual (Page 35)

5. Fasten the mounting base onto
the dashboard with the tapping
screws.
CAUTION
• Before drilling any mounting
holes, confirm that the screws
will not interfere with any of the
vehicle’s operating systems (such
as the fuel line, brake lines, elec-
trical wiring, etc.).
6. Adjust the display vertical posi-
tion and display angle.
In order to stabilize the display, adjust
the display vertical position so that the
bottom of the display base contacts the
dashboard. Adjust the display to a
good angle for viewing.
Note:
• After you have adjusted the display vertical
position and angle, turn the knobs clockwise
to fasten the display in place.
34
ENGLISH
ESPA
Ñ
OL
DEUTSCH
FRAN
Ç
AIS
ITALIANO
NEDERLANDS
Tapping screws
(3
× 12 mm)
If you turn this knob to the left, you
can adjust the vertical position of
the display.
If you turn this knob to the left, you
can adjust the angle of the display.
Dashboard
Dashboard