Precor p20 User Manual

Page 73

Assembling the EFX

3. Check alignments and thread the remaining four center

column support screws, four ⁵₁₆-inch washers, and four

split washers. Tighten with a ³₁₆-inch hex key so the

assemblies come together, but leave room for

adjustments.

Figure 9: Center column support attachment

To tighten the fasteners properly:

CAUTION: Upright support fasteners must be properly aligned

and wrench-tightened in the order described below. If improperly

assembled, the upright supports can rub against the ramp. Before

you begin, verify that the base and lift covers are properly aligned

and that the gap between them is even. If not, move the upright

supports until the covers are properly aligned.

1. Fully tighten the two sets of fasteners on the back of the

center column support.

Figure 10: Tighten fasteners on back of the center column

support