Precor p20 - Manual (Page 33)

Introducing Users to the P20 Console
31
If the restart switch trips during exercise, perform the
following steps:
1. Reattach the safety clip if necessary.
2. Press the restart switch down until it clicks, returning it to
its normal position.
Note: If the restart switch trips, all information about the
current workout is deleted.
3. Start the workout from the beginning, reducing the time
as needed to account for the amount of exercise that has
been completed.
Figure 7: Attaching the safety clip
Treadmill Auto Stop™ (Automatic Stop)
Function
Important: The default setting for this feature is ON. An
administrator can turn off this feature in the System Settings;
however, Precor recommends it remain ON.
The Auto Stop™ (Automatic Stop) feature is designed to
bring the treadmill to a gradual stop when it is not in use. This
might occur if a user steps off the treadmill before the end of
a workout and leaves the treadmill running.
Sixty seconds after a treadmill workout starts or resumes, the
equipment begins Auto Stop monitoring. If a user is detected,
then no message appears, and the selected workout
continues.