Pioneer VSX-D914 - Manual (Page 65)

Additional information 11
65
En
Chapter 11:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
Problem Remedy
The power does not turn on. • Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power repeatedly shuts off automatically, take the unit to
your
nearest Pioneer authorized service center or your dealer for
servicing.
No sound is output when a
function is selected. • Make sure the component is connected correctly (refer to Con-
necting up on page 16).
• Press MUTE on the remote control to turn muting off.
No image is output when a
function is selected. • Make sure the component is connected correctly (refer to Con-
necting up on page 16).
• Select the correct component (use the MULTI CONTROL buttons).
Considerable noise in radio
broadcasts. • Tune in the correct frequency.
• Connect the antenna (refer to page 20).
• Route any loose cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 20).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 20).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Place the antenna farther away from the equipment causing the
noise.
VSX_D912.book.fm 65 ページ ２００３年１２月５日 金曜日 午前９時４３分