Philips WVH111 - Manual (Page 10)

10
G
ETTING
S
TARTED
(
CONT
’
D
)
B ACK P ANEL
~Mains
Connect the power cord here. Please connect this last.
Details are on page 17.
Tel Line
Connect the telephone line here. Details are on page 15.
RF (Radio Frequency) IN
Connect the antenna, cable signal, or coaxial cable here.
Details are on page 11.
Video Out
Connect the yellow video cable here and to the VIDEO IN
jack of a TV or VCR.
Details are on page 13.
Audio Out Left/Right
Connect the red and white audio cables here and to the
AUDIO IN jacks of a TV, VCR, or stereo.
Details are on page
13-14.
Printer
Connect a parallel printer cable here and to the printer port
on your printer, if applicable. Details are on page 17.
Reset
Press to reset the Set Top Box.
USB (Universal Serial Bus)
For future enhancements
IR Blaster
Connect the IR Blasters here. Details are on page 16.
Audio In L/R (left/right)
For incoming audio. You might not use these jacks.
Video In
For incoming video. You might not use these jacks.
S-Video Out
Connect an S-Video cable (not supplied) here and to the S-
VIDEO IN jack of a TV or VCR. This connection will provide
the best picture quality. If you connect the Set Top Box to
the TV using an S-Video cable, do not connect the yellow
video cable. Details are on page 14.
RF (Radio Frequency) OUT
Connect a coaxial cable here and to the RF IN or ANTEN-
NA IN jack of your TV or VCR. Details are on page 12.
Class 2
U.S. Requirement: Use Class 2 wiring accord-
ing to the National Electrical Code (NEC) to
make connections to the USB port.
CAUTION
DO NOT TOUCH THE INNER PINS OF THE
BACK PANEL CONNECTORS.
ELECTROSTATIC DISCHARGE MAY CAUSE
PERMANENT DAMAGE TO THE UNIT.