Polaroid SprintScan 45 User Manual
Page 16
Setup and use
2-7
The second port (25-pin) can be used to connect another SCSI
device to the chain, using another SCSI cable.
3
Terminate the signal at the last device in the chain. If the scan-
ner is the last device, connect the terminator provided to the
50-pin port. Then connect the SCSI cable to the terminator
(picture 3). Be certain to use only SCSI-specified cables for all
connections in the chain. For details, see pages 2-8–2-9.
The diagrams on the following pages will serve as a reference
to correct SCSI connections for various system configurations.
4
Change the SCSI address of the scanner, if necessary, by press-
ing the button marked (-) or (+) above and below the switch;
see page 2-5 for details.
3