Primera Technology RX900 - Manual (Page 48)

44 Printing
Best for Photos mode is best used for photographic images
where accurate color reproduction is very essential. Images
printed in this mode will look lighter than those printed in
Photo mode. Skin tones especially will look more natural in
this mode.
NOTE: Exact color matching of the printed labels to the screen may never
be possible since there are factors that affect this out of the drivers
control. The surface of the label reacts with the ink in the cartridge to
produce the color. For this reason, when printing the same image to
different types of labels with different surfaces the printed output can
look entirely different.
Ink Saturation
This option controls the amount of ink used when printing an
image. The default setting is 100%, which will provide the
most accurate color matching. If the ink is not drying fast
enough or bleeding, you can decrease the Ink Saturation to
lessen the amount of ink that is applied to the label.
Enable Bi-di Printing
This setting defaults to “Yes” for fastest bidirectional printing.
Stock Sensor Mode
Click this setting to open the Status Monitor. See Section 2D
Output Mode
Click this setting to open the Status Monitor. See Section 2E
Print Alignment
Click this setting to open the Status Monitor. See Section 4D
Cartridge Maintenance
Click this setting to Align the Printhead, Clean the Printhead
or Change a Cartridge. This setting opens the Status Monitor.
RX900.qxd 2/17/2011 1:31 PM Page 44
TOC INDEX