Philips SC362 - Manual (Page 5)

4
A
DDITIONAL FEATURES
Avoiding interference
Both units use anti-interference technology to reduce the chance of interference from other
signals. If interference does occur or if sound reception is poor, try switching both units to
the other channel to improve the sound quality.
Note : Always make sure that the channel selection switches (A–7, B–6) on both units are
set to the same position.
Belt clip
If the Parent unit is operating on batteries, you can carry it around giving you freedom of
movement while still monitoring your baby. Use the belt clip (B–7) to attach the unit to your
clothing and so keep your hands free. The belt clip can be removed by unclipping the top
and sliding it downwards.
H
OW TO USE THE BABY MONITOR
Monitoring baby’s sounds
To use the units to listen to your baby:
• Position the Baby unit at least 1 metre away from the baby so that the microphone (A–4)
can pick up baby’s sounds.
• Set the channel switch to the same position on both units.
• Set the mode switch on the baby unit (A–6) to VOICE; the red POWER light (A–1) lights.
• Move away from the Baby unit with the Parent unit.
• Switch on the Parent unit using the Volume control/Off (B–3) and adjust the volume to
the level you prefer; the red POWER light (B–1) lights.
• The green TRANSMIT light (A–2) lights when a sound is picked up by Baby unit.
Talk pushbutton
To use the Baby unit manually to talk to the Parent unit:
• Set the mode switch on the Baby unit (A–6) to OFF.
• Switch on the Parent unit using the Volume control/Off (B–3) and adjust it to about mid-
range; the red POWER light (B–1) lights.
• On the Baby unit, press and hold the TALK pushbutton (A–3) and talk clearly into the
microphone (A–4). Release the TALK pushbutton when you are finished.