Pentair 720 - Manual (Page 9)

5
Prowler ™ 720 and 730 Installation and User’s Guide
10 ft. / 3m
Handle Lock Mechanism
Operating the Prowler ™ 720 and 730 Cleaners, cont’d.
1. Place the power supply, (transformer), at
least ten feet / three meters from the pool as
shown in Figure 2. The transformer will
supply low voltage to the cleaner.
2. Uncoil the cable as shown in Figure 3.
3. For proper operation, lock the moveable
handle diagonally across the top of the
cleaner's body. Push down on the handle
lock mechanism and slide the handle all the
way to the end, (we recommend one slot
before the end), then release the lock. The
handle will remain fixed in this position.
Repeat this process on the other side of the
cleaner. Remember, the handle must be
fixed diagonally, see Figures 4 and 5.
4. Place the unit in the water. Turn the unit
side to side in the water to allow air to
escape from the body and then let the
cleaner sink to the bottom of the pool, see
Figure 6. Then, spread the cable over the
surface of the pool as evenly as possible as
shown in Figure 2.
5. Plug the cable into the power supply. Make
sure the key on the plug exactly corresponds
with the key slot on the socket of the power
supply, see Figure 7. Plug the power supply
into a grounded outlet. Make sure that the
electric outlet has been properly grounded,
see Figure 8. The light will glow indicating
that the system is “ON” and the pool cleaner
will start the cleaning cycle. The unit keeps
record of the number of cleaning cycles.
Only an authorized service center can display
the accumulated cleaning cycles. (See
details on the next page.)
Figure 2.
Figure 3.
Figure 5.
Figure 6.
Figure 7.
Transformer
Plug
Transformer
Socket
Figure 8.
Figure 4.