Pentair 720 - Manual (Page 11)

7
Prowler ™ 720 and 730 Installation and User’s Guide
Wireless Remote Control - only for Prowler ™ 730 cleaners equipped with Remote Control
Using Radio Remote Control Feature and Accessing Cleaning Modes
The Remote Control Model is equipped with a multi-directional
radio transmitter, see Figure 12. This feature will enable you to
guide the pool cleaner directly to areas of the pool requiring
additional cleaning attention or for quick clean-ups. When you
press the Right or Left buttons, the cleaner will turn until the
button is released. Then, the cleaner will proceed straight ahead
in the new direction. Pressing the Forward/Reverse button will
cause the cleaner to proceed in the new direction after the button
has been released.
Cleaning Modes
The Remote Control has an advanced cleaning program with two
options:
Option 1: STANDARD MODE — this cycle is 1½ hours long and
cleans the bottom of the pool only.
Option 2: SUPER MODE — this cycle cleans the bottom and the
walls of the swimming pools. This cleaning program is 3 hours
long and is registered in the cycle counter as two cycles (one for
each 1.5 hours of use). Every time a cleaning cycle is complete
the cleaner will stop automatically. Every remote control unit is
shipped from the factory with the “Standard Mode” as the primary
program. To switch from the “Standard Mode” to the “Super Mode”, simply press the "Program" button once.
The cleaner will immediately receive the command and will start to clean the bottom and the walls. Your signal
that the cleaner is in the “Special Mode” is that the machine will climb up to the waterline in the first contact with
a wall. To return to the “Standard Mode”, simply press the “Program” button again, ONLY when the machine is
on the pool bottom.
NOTE: When the Power Supply is turned off, the Mode is automatically returned to the "Standard Mode" (floor
cleaning only).
CAUTION — Be sure to always keep your Pentair pool cleaner properly stored anywhere between 50° to 104°
Fahrenheit, (10° to 40° Celsius). This will keep the motors, plastics and seals protected. Failure to
comply will result in loss of warranty.
Forward / Reverse
Right
Left
LED
Program
Figure 12.