Philips FW 358C - Manual (Page 16)

16
3139 116 17942
English Storing Preset Stations
You can store up to 40 radio stations in the memory.
When a preset radio station is selected, the preset
number appears next to the frequency on the display.
Automatic programming
1 Press TUNER.
2 Press TUNER (BAND) again to select the desired
waveband : FM, MW or LW.
3 Press PROGRAM for more than one second.
™ PROGRAM flag starts flashing and ‘AUTO’ will be
displayed.
™ Every available station for the selected waveband
will be stored automatically. The frequency and
preset number will be displayed briefly.
™ The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
™ The system will remain tuned to the last stored
preset radio station.
• Repeat the above procedure to store other preset radio
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
Notes:
– You can cancel the automatic programming by
pressing PROGRAM or STOP Ç (on the system only) .
– If you want to reserve a section of preset numbers, for
example preset numbers 1 to 9, select preset 10
before starting automatic programming: now only the
preset numbers 10 to 40 will be programmed.
TUNER
Manual programming
1 Press TUNER.
2 Press TUNER (BAND) to select the desired waveband
: FM, MW or LW.
3 Press PROGRAM for less than one second.
™ PROGRAM flag, the frequency and preset number
start flashing.
™ The next available preset number will be displayed
for selection.
4 Press TUNING à or á to tune to the desired
frequency.
• If you wish to store the radio station to another preset
number, press PRESET 4 or 3 to select the desired
preset number.
5 Press PROGRAM again.
™ PROGRAM flag will stop flashing, and the radio
station will be stored.
• Repeat the above procedure to store other preset radio
stations.
Notes:
– When 40 radio stations are stored and you attempt to
store another radio station, the display will show
"
PROGRAM FULL”. If you want to change an
existing preset number; repeat steps 4 and 5.
– You can cancel manual programming by pressing
STOP Ç (on the system only) .
– During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically.
Tuning to Preset Radio Stations
• Press PRESET 4 or 3 to select the desired preset
number.
™ The preset number, frequency and waveband
appear on the display
Receiving RDS radio station Ç
RDS (Radio Data System) is a broadcasting service that
allows FM stations to send additional information along
with the regular FM radio signal. This additional
information can contain:
• STATION NAME: The station name is displayed.
• FREQUENCY: The frequency of the station is
displayed.
• PROGRAM TYPE: The following program types exist
and can be received by your tuner: News, Affairs, Info,
Sport, Educate, Drama, Culture, Science, Varied, Pop
M, Rock M, M.O.R. (middle of the road music), Light
M, Classics, Other M, No type.
• RADIO TEXT (RT): text messages appear in the
display.
When you have tuned to a RDS station, the RDS logo ( Ç)
and the station name will appear on the display:
• The display normally shows the radio station name if
available. By repeatedly pressing RDS button you can
change the type of display information:
™
The display shows in turn:
STATION NAME ™ FREQUENCY ™
PROGRAM TYPE ™ RADIO TEXT ™
STATION NAME ...
Untitled-26 6/15/00, 4:52 PM 16