Phonetics 1104 - Manual (Page 27)

Chapter 3: Quick Start
15
Chapter 3: Quick Start
This section presents a useful guide for first-time programming
of the Model 1104. Follow instructions for installation before
attempting to program the Model 1104. Refer to
Chapter 2: Installation.
3.1 The Local Keypad
Programming is accomplished using the local keypad (shown
below, Figure 3-1). Notice that a single key has several
functions assigned to it; programming results are determined
by the order in which keys are pressed.
Individual keystrokes are illustrated to show programming
steps in the correct order. If you make a mistake by entering the
wrong key, do not press another key until you hear the message
“Error 1.” Then, start over with the first key in the
programming sequence.
SET
#
WHAT
IS
*
SENSOR
ON/OFF
PHONE
NUMBER
RING/TAD
PAUSE
AM
ENTER
TONE
PM
STATUS
CONFIGURE
STANDBY
TEMP CODE
RUN
Fº/Cº MUTE
1 2 3
4 5 6
7 8 9
0
CALL
DELAY
VOICE
REPS
INTERCALL
TIME
MAX CALLS TEMP LIMITS CALIBRATE
RECOGNITION
TIME
CLOCK
LISTEN TIME
SOUND
ID NUMBER
POWER
Figure 3-1. The Model 1104 Keypad