beautypg.com

Operating heater – Procom QL300RYLA User Manual

Page 11

background image

1 1

OPERATING HEATER

FOR YOUR SAFETY

READ BEFORE LIGHTING

A. This appliance has a pilot which

must be lighted by control system,
When lighting the pilot, follow
t h e s e i n s t r u c t i o n s e x a c t l y .

B. BEFORE LIGHTING smell all

around the appliance area for
gas. Be sure to smell next to the
floor because some gas is
heavier than air and will settle
on the floor.

WHAT TO DO IF YOU SMELL GAS

SEE WARNING in Page 1 for proper
instructiors.

WARNING:

If you do not

follow these instructions exactly, a
fire or explosion may result causing
property damage, personal injury or
loss of life.

Fig 13 Front of the Transmitter

NOTICE:

During initial opera-

tion of new

fireplace

, burning logs

will give off a paper-burning smell.
Orange flame will also be present.
Open a window to vent smell. This
will only last a few hours.

CAUTION:

Do not try to adjust

heating levels by using the
equipment shutoff valve.

OPERATING INSTRUTION OF

REMOTE-CONTROLLED BUNER

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information,
page 2.
2. Make sure equipment shutoff

valve is fully open.

Figure 12-1 Emergency Button
location

C. Use only your hand to push in
control knob. Never use tools. If the
the appli ance could not operate , don't
try to repair it, Call a qualified service
technician or gas supplier.Forced or at-
tempted re-pair may result in a fire or
explosion.
D. Do not use this appliance if any
part has been under water. Imme-
diately call a qualified service techni-
cian to inspect the appliance and to
replace any part of the control system
and any gas control which has been
under water.

TO TURN OFF GAS TO APPLIANCE

Shut off heater

1. Press the IGN/OFF button of
transmitter.
2.Set the Switch on OFF location.(See
Figure12-2)

Shutting off burner only( pilot stay lit)

1.press the BURNER to set flame OFF
select

If you didn’t receive or mis-place your
remote transimitter,you can press the
emergency button by a pitch rod to
operate remote automatically

on

or

off

(see fig 12-2)

Figure 12-2 On/Off Switch

This manual is related to the following products: