Panasonic EP1060 - Manual (Page 17)

17 16
MANUAL OPERATION
neck roller position reclining
programmed
operation
/ manual
operation
intensity
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
position
1
3
4
1. Press button
• The ON/OFF lamp will come on.
• You can now select either Strong or Gentle or one of the manual
settings that can be accessed by opening the cover of the
controller.
2. Open the Cover of the Controller
• All of the manual operation buttons will start
to flash.
3. Selecting the Massage Type Required
• Press the button of the massage you require.
The button will be lit.
• The seat will automatically recline to the massage position.
E.g. Selecting Knead.
4. Adjusting Manual Massage Settings
Adjusting the Vertical Position of the Massage Heads
• The massage heads will move a little each time the button is
pressed. If you hold down the button, the massage heads will
continue to move until you release the button. When the
massage heads reach their limit you will hear a “peep, peep,
peep” sound.
Adjusting the Width between Massage Heads
• Vibration, Tap, Shiatsu Whole Back Roll, and Regional Roll
can be adjusted in 5-stages while Swedish (gentle) can be
adjusted in 3-stages.
• As Swedish covers the entire width of the back, it is not
possible to adjust width settings.
• The massage heads will move a little each time the button is
pressed. If you hold down the button, the massage heads will
continue to move until you release the button.
• When the massage heads reach their limit you will hear a
“peep, peep, peep” sound.
• As Roll or combining Roll with other massages sometimes
produce an especially strong massage, adjustment is limited
to medium or weak.
MANUAL OPERATION FOR THE UPPER BODY
neck roller position reclining
programmed operation / manual operation
intensity
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
position
slow fast leg massage
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
Combining Massages
• It is possible to combine massage types.
• It is not possible to combine massage types in the same category.
E.g.1 Adding Tap B when Knead is selected.
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
E.g.3 Toggling off Roll pressing it again.
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
E.g.2 Adding Roll to the selection.
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
E.g.2 Changing to a massage type outside the category.
(Changing to Tap B when Knead is selected.)
• When Knead is combined with Tap B, deselecting Knead will leave only Tap.
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
Press
Press
Press
Press
Press
Press
position position
Raising the massage heads Lowering the massage heads
Press
Press
position position
Increasing the width Decreasing the width
Press Press
Roll, Roll + (Shiatsu, Tap B, Tap A, Vibration) Combination..................................Weak/Medium only
Roll + (Knead, Swedish Combination) ...................................................................Weak only
• For Tap B, Swedish, and Vibration, unless the massage heads are actually touching the body then you may
not feel the movement.
5. Auto Stop in Manual Operation
• A timer will automatically stop the unit approximately 15 minutes (15–17 minutes) after the massage started.
(This is to prevent overuse in the interests of safety.)
• The massage heads will move to the retracted position and stop.
• The ON/OFF lamp will flash until the heads have stopped moving.
• If you want to start another massage, please press
button.
• Please rest at least 10 minutes between massages.
6. Stopping Manual Operation
Press button to stop manual operation.
• The ON/OFF lamp will continue to flash until the massage heads have returned to the retracted position.
Changing Massage Types
E.g.1 Changing massage types in the same category.
(Changing to Shiatsu when Knead is selected.)
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead
roll
manual operation
whole back regional
tap A vibration tap B
swedish shiatsu knead Press
Adjusting Massage Intensity
• Massage intensity can be adjusted up to 3 levels.
• When the massage heads reach their limit you will hear a “peep,
peep, peep” sound.
intensity intensity
Increasing massage intensity Decreasing massage intensity
Press Press