Paxar Monarch Sierra Sport2 - Manual (Page 24)

3-4 Care & Maintenance
7. Clean the on-demand and black mark sensor with
a clean soft cloth or cotton swab moistened with
isopropyl alcohol or a cleaning pen.
8. Reload the supply.
9. Close the supply door until the release buttons
click into place.
10. Turn on the printer by pressing and holding P
until the display appears.
Clearing Label Jams
When you are printing and jam occurs, a supply error
message appears. To clear the jam:
1. Turn off the printer by pressing and holding P
until the display is blank.
2. Push down on the release buttons on both sides of
the printer to open the supply door. The supply
door should swing open.
3. If necessary, remove the roll of supplies.
4. Remove the jammed supplies and reload the
supply.
5. Close the supply door.
6. Turn on the printer by pressing and holding
P
until the display appears.
Black Mark
Sensor
On-Demand
Sensor