Planar PT1710MX - Manual (Page 24)

20
Touch Screen Driver Installation
The touch driver is located on the enclosed CD-ROM for these
operating systems: Windows Me/2000/XP series.
Driver Installation Process:
1. Before you start to install the touch driver, please be sure the USB or the
RS-232 Serial cable is disconnected from the PC or the LCD display.
2. Uninstall any touch screen driver (excluding Gunze) tha may be on your
system.
3. Click on the PT1710MX driver link found on the CD-ROM.
4. Follow instructions as found in the driver installation process and the
Touch Set-Up Guide on the CD-ROM.
5. After installation is complete, click “Finish” and restart your computer to
complete installation.
Touch Panel Setting and Calibration:
1. After restarting your computer, click “Start” on the Windows toolbar.
2. Select “All Programs” and select “Gunze TPDD”.
3. Select “Adjust Settings”.
4. Select “Devices” tab and click “Add”.
5. Select “Gunze USB” if using a USB cable to connect between the monitor
and PC from the New Pointer Device menu. See Figure 1.