The initial setup menu 13, Video in / out settings, Input colour system – Pioneer PRV-9200 User Manual

Page 98: Component video out

The Initial Setup menu

Select ‘VCR Plus+ CH Setting’, then ‘Next Screen’.

Assign channel numbers to the guide channels as

necessary.
Look in your TV guide to see which channel numbers
should be assigned to which guide channels.

• Use the

/ (cursor up/down) buttons to change

the guide channel for setting.

• Use the

/ (cursor left/right) buttons to change

the channel number.

• Use the

PREV / NEXT button to display the previous/

next 10 guide channels.

To return to the Initial Setup menu, press ENTER.

Video In / Out settings

Input Colour System

• Default setting:

Auto

On the default setting, the recorder automatically detects
whether the video signal from the built-in tuner or from
one of the external inputs is 3.58 NTSC, PAL–60, PAL or
SECAM. You may, however, occasionally need to set it
manually if the picture is not displayed properly.

Select ‘Input Colour System’, then ‘Next Screen’.

Use the CHANNEL +/– buttons or the INPUT

SELECT button to switch between the built-in tuner
and the external inputs.

Use the

/ (cursor left/right) buttons to

change the input colour system for the current input
or built-in tuner.

• The available settings depend on the Input Line

System setting (see

Input Line System on page 96).

The table below shows the different options available.

Component Video Out

• Default setting:

Interlace

You only need to make this setting if you connected this
recorder to your TV using the component video jacks.

If your TV is compatible with progressive-scan
component video, set this

Progressive for the highest

quality picture. If your TV is not compatible with
progressive-scan video, leave it set to

Interlace.