POLAR FIN-90440 - Manual (Page 17)

35 34
Limited Polar
Warranty
• Polar Electro Oy warrants to the original consumer/
purchaser of this heart rate monitor that the product will be
free from defects in material or workmanship for one year
from the date of purchase. Please keep the receipt which is
your proof of purchase!
• Warranty does not cover receiver battery, damage due to
misuse, abuse, accidents or negligence of the precautions;
improper maintenance, commercial use, cracked or broken
cases.
• Warranty does not cover damage or consequential damage
caused by service not authorized by Polar Electro.
• During the warranty period the product will be either
repaired or replaced at an authorised service centre free of
charge.
• This warranty does not affect the consumer's statutory
rights under applicable national or state laws in force, or
the consumer's rights against the dealer arising from their
sales/ purchase contract.
Copyright © 1997, 2001
Polar Electro Oy, FIN-90440 KEMPELE, Finland
All rights reserved. No part of this manual may be used or reproduced in any
form or by any means without prior written permission of Polar Electro Oy.
Polar logotype is a registered trademark and Polar Fitwatch is a trademark of
Polar Electro Oy
This CE marking shows compliance of this product with Directive 93/42/EEC.
SENDING INSTRUCTIONS
1. Pack the product carefully to avoid further damage.
2. Include all the parts of the Polar Heart Rate Monitor. A full
periodic check will be done on the whole product.
3. Include proof of purchase (a receipt or its photocopy) if the
product is under warranty.
4. Include a detailed description of the problem. Use the
return sheet of the Customer Care Charter.
5. Include your name, return address and daytime telephone
number.
6. Ship postage prepaid to your dealer or distributor. For
contact details see the Customer Care Charter.
POLAR’S SERVICE PROCEDURE
Any service is recommended to be done by authorised Polar
service personnel. Our standard test and check procedure will
be performed to all Polar Heart Rate Monitors. The test
includes following elements:
POLAR TRANSMITTER
1. Visual inspection
2. Check of the transmission range
3. Check of electrode conductivity
4. Wash and clean if necessary
POLAR WRIST RECEIVER
1. Visual inspection
2. Check of battery voltage
3. Check and cleaning of case contacts
4. Re-assembly, including seal renewal if necessary
5. Water resistance test
6. Operational test
Water resistance cannot be guaranteed after
unauthorised service.
0537
FITWATCH.manual GBR/E 5.1.2001, 10:55 34-35