beautypg.com

Settings, English, Changing auto speaker settings – Panasonic SA-XR700 User Manual

Page 34: Making bi-amp settings, Surround speakers enter, Menu, Audio, Rsetup mic

background image

34

RQT8743

Settings

See page 32 for receiver operations.

Changing auto

speaker settings

1) Among speaker settings

made with the setup
microphone, you can return
polarity and frequency to
factory settings. (The “AUTO
SPEAKER SETUP” indicator
goes off when you perform
this operation.)

2) The unit judges polarity of

certain properly connected
speakers as opposite. When
this happens, set the unit
against automatic polarity
adjustment and prevent
polarity reversal.

1) To return

speakers to
factory
settings

1 Select and confirm the choice.

2 Select and confirm the choice.

3 Select and confirm the choice.

• To cancel, press “

NO ”.

YES :

For returning to factory settings

NO :

For keeping auto settings

2) Setting the

unit against
automatic
polarity
adjustment

1 Select and confirm the choice.

2 Select and confirm the choice.

3 Select and confirm the choice.

CHECK YES :

Normal auto speaker setup

CHECK NO :

No automatic polarity

adjustment

Making BI-AMP

settings

• BI-AMP settings appear

on the display and
become selectable only
when you set bi-wire
speakers (
á page 20).

1) You can drive speakers

with front, surround and
surround back speaker
amps instead of using
BI-AMP (triple amp
mode).

2) You can adjust HF (high

frequency) and LF (low
frequency) output
balance of the bi-wired
speakers.

3) You can reduce the

delay time due to the
difference in size of the
HF and LF units.

1) Cancelling

BI-AMP
(using the
triple amp
mode)

1 Select and confirm the choice.

2 Select and confirm the choice.

3 Select and confirm the choice.

• The “BI-AMP” indicator goes off when the

unit enters the triple amp mode.

AUTO :

When using BI-AMP

OFF :

When not using BI-AMP (when

using the triple amp mode)
Factory setting :

AUTO

2) Adjusting the

balance

1 Select and confirm the choice.

2 Select and confirm the choice.

3 Make adjustment and confirm the choice.

LF : Low frequency

HF : High frequency

3) Correcting

the HF and
LF difference

1 Select and confirm the choice.

2 Select and confirm the choice.

3 Make adjustment and confirm the choice.

Adjustment range:

0 to 30 cm

You can select differences at

1 cm intervals.
Factory setting:

0 cm

Setting ADVANCED

DUAL AMP off

1 Select and confirm the choice.

2 Select and confirm the choice.

AUTO :

Advanced dual amp is on

OFF :

Advanced dual amp is off
Factory setting:

AUTO

-MENU/-SETUP ENTER

INPUT SELECTOR

VOLUME

BI-AMP

SURROUND

SURROUND

SPEAKERS

AUTO DETECTOR

TUNE

AUX

ADVANCED DUAL AMP

AUTO SPEAKER SETUP

SETUP MIC

HDMI

RETURN

SURROUND

SPEAKERS

ENTER

-

MENU/

-

SETUP

AUTO DETECTOR

RETURN

TUNE

AUX

S VIDEO

VIDEO

L

-

AUDIO

-

R

SETUP MIC

INPUT SELECTOR

-

MENU/

-

SETUP ENTER

RETURN

“BI-AMP”

The bar shows the standard balance.

Difference

Difference

Difference

(Side view of a speaker
in cross section)

cm

Settings

ENGLISH

SA_XR700_EG_GN_ (RQT8743_B)ver.3.fm 34 ページ 2006年8月31日 木曜日 午前9時7分