Philips 1EMN26039A - Manual (Page 13)

12
Switching channels
Press CHANNEL + / − on the side of the TV. For digital channels, press
a number (1 to 135) followed by a dot “•” and then the corresponding
sub channel number (1 to 135). e.g. 108.30.
• Press
CH + / − or enter a number on the remote control.
• Press PREV CH to return to the previously viewed channel.
5 Use your TV
This section helps you perform basic TV operations.
Switching on your TV and putting it in
standby mode
To switch on
• Press
. POWER at the side of the TV or press . (standby-On)
on the remote control.
To switch to standby
• Press
. POWER at the side of the TV or press . (standby-On)
on the remote control again.
Note
• Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
EN