Philips 1EMN26039A - Manual (Page 25)

24
Autoprogram
Before you install channels, ensure that you are registered with your
cable TV provider and that your equipment is correctly connected.
1
Press MENU on the remote control and select [Setup] >
[Autoprogram].
Picture
Sound
Setup
Features
Language
USB
Channel List
Add Channels
Antenna
Autoprogram
2
Press OK to start the installation.
If you run [Autoprogram] when you have locked channels, a
message appears asking to enter your PIN . Enter your PIN in
order to complete the installation.
If you have forgotten your PIN, reset it as described in ‘Changing
your PIN’ on page 18.
3
Select [Antenna] or [Cable] and press OK.
• When [Antenna] is selected, the TV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
• When [Cable] is selected, the TV detects signals supplied
by cable. It searches for NTSC, ATSC, and QAM modulated
channels available in your area.
Picture
Sound
Setup
Features
Language
USB
Antenna
Cable
Back
Autoprogram will rescan all channels.
Auto programming may take more than 20
minutes to complete.
Select your signal source.
Antenna
Cable Or
ANT.IN
• When autoprogramming is complete, the lowest memorized
channel will be displayed.
4
Follow the on-screen instructions to complete the installation.
7 Install channels
The fi rst time you set up your TV, you are prompted to select a menu
language and to install TV and digital radio channels (if available). This
chapter provides instructions on how to reinstall and fi ne-tune channels.
Selecting your menu language
1
Press MENU on the remote control and select [Language].
Picture
Sound
Setup
Features
Language
USB
Select your menu language.
Seleccione el idioma para el menú.
Sélectionnez la langue du menu.
English
Español
Français
2
Select a language and press OK to confi rm your choice.
3
Press MENU to exit.
EN