Philips DVP3345V/F7 - Manual (Page 28)

English
28 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
● Turn on the TV and set it to the correct Video In channel.
(Check your TV owner’s manual for details.)
1 Press INPUT repeatedly until “DISC” appears on the
TV screen.
2 Press SPEED repeatedly until the desired tape
speed (SP or SLP) appears briefly on the screen.
Details about tape speed are on page 57.
3 Press REC I to start recording. “REC” will appear on
the display panel.
4 Press DVD. Press PLAY B to play the disc.
● To pause the recording, press VCR, then press
PAUSE k once. “REC” will flash.
● To resume recording, press REC I or press PAUSE k
again. “REC” will reappear.
● To stop recording, press VCR, then press STOP C.
DISC
2
4
DVD VCR SETUP
INPUT MENU
REC SPEED MODE
ANGLE SEARCH REPEAT
DISPLAY SUBTITLE ZOOM
TIMER SET
REPEAT
A-B
AUDIO
BACK PAUSE STOP
PLAY
OK
FFW REW
CLEAR TITLE
DISC
TRACKING
OPEN/CLOSE
1 2
6 5 4
7 8 9
0 +10
3
• A Timer Recording or Satellite
Link is not available during DVD
to videotape duplication.
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan.
Helpful Hints
1
3
E8E21UD_EN1.qxd 09.1.23 2:42 PM Page 28