Paxar Monarch RF Link 7400 - Manual (Page 3)

14 RF link Operating Instructions RF link Operating Instructions 3
If the printer and terminal are not communicating, try each of the following
items:
♦
Change or recharge the batteries.
♦
Correct the orientation of the batteries in the compartment.
♦
Re-link the printer and terminal.
♦
Move the modules closer than three meters apart.
♦
Move the terminals and the printers around to find the best relative
position between the two.
♦
Swap in new printers and terminals to narrow the problem down to a
particular unit.
Returning RF link to Monarch
If you determine there is still a problem with your RF link modules after you
perform the troubleshooting procedure, call Monarch at the phone number
listed at the end of these instructions. The person you speak with may
decide that you must return RF link to Monarch. When you send it back, use
the original packaging (box and packing material) and include these
Operating Instructions.
Use the following address:
Monarch ERC
200 Monarch Lane
Door 39
Miamisburg, OH 45342
The warranty does not apply if you do not follow these instructions.
LDT/LRT 3800 and PDT 6800 PDT 3100
I n s t a l l i n g R F l i n k M o d u l e s
The modules fit differently on their units because of each unit's unique
features. Therefore, the module installation instructions differ with each
unit.
LDT/LRT 3800 and PDT 6800
To install the RF link module onto the LDT/LRT 3800 and PDT 6800:
1. Insert a 9-volt (PP3) battery in the module. See “Inserting Batteries” for
more information.