Pioneer DVH-P5650MP - Manual (Page 83)

Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put) can be used for full-range speaker
(R-SP :FUL) or subwoofer (R-SP :S/W) connec-
tion. If you switch the rear output setting to
the R-SP :S/W, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (R-SP :FUL). When rear output is
connected to full range speakers (when
R-SP :FUL is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controllers (low pass filter, phase)
built-in P/O :S/W or the auxiliary P/O :FUL.
1 Press F to select R-SP.
Press F repeatedly until R-SP appears in the
display.
2 Press r or q to switch the rear out-
put setting.
Pressing r or q will switch between
R-SP :FUL (full-range speaker) and R-SP :S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select R-SP :FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP :S/W.
# When the rear output setting is R-SP :S/W,
you cannot change the subwoofer controller.
3 Press m or n to switch the subwoo-
fer output or non fading output.
Pressing m or n will switch between
P/O :S/W and P/O :FUL and that status will
be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 61)
or subwoofer output (refer to Using subwoofer
output on page 60) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
1 Press F to select TEL.
Press F repeatedly until TEL appears in the dis-
play.
2 Press m or n to switch the tele-
phone muting/attenuation.
Pressing m or n will switch between
TEL :ATT (attenuation) and TEL:MUT (muting)
and that status will be displayed.
# You can select in the following setting:
! TEL:MUT Muting
! TEL :A20 Attenuation (TEL :A20 has a
stronger effect than TEL :A10)
! TEL :A10 Attenuation
Notes
! The sound is turned off, MUTE or ATT is dis-
played and no audio adjustment is possible.
! Operation returns to normal when the phone
connection is ended.
Initial Settings
En
83
Section
14
Initial
Settings