PAR Technologies PARASTATION5 V5 User Manual
Page 88
84
ParaStation5 Administrator's Guide
Provided the ParaStation daemon is started by the xinetd, run the psiadmin(1) command located in
/
opt/parastation/bin
and execute the
add
command. This will bring up the ParaStation daemon
psid(8) on every node.
# /opt/parastation/bin/psiadmin
psiadmin> add
Alternatively you can start psiadmin(1) with the
-s
option.
To install the ParaStation daemon as a system service, started up at boot time, use
# chk_config -a /etc/init.d/parastation
This step must be repeated for each node.
7. Testing
A brief test of the entire communication and management system can be accomplished by using the
test_nodes(1) command. For a detailed description please refer to Section 4.3, “Testing the installation”.