Polycom Wireless Microphone System - Manual (Page 9)

To access digital services, such as voice mail, where only pulse dialing is available,
SoundStation Premier can provide temporary tone dialing. When the phone is
ON , press
SHIFT , then press REDIAL . The display must read TONE DIALING for this feature to be
activated. Once the phone is hung up, dialing will revert to its previous mode.
To place or answer a phone call
Press ON/OFF to turn the unit on and dial the number. The display will go blank, then show
each number as it is being dialed.
For incoming calls and when caller identification is activated, the display will show the
caller’s phone number. The time of day clock will be initiated once a call is made to the phone.
Once the call is connected, a clock will appear on the display showing how long the call has
been in progress.
To adjust tone volume and speaker volume
When the phone is on and dial tone is heard, adjustment of the dial tone volume can be made
by pressing
VOL or VOL .
NOTE: There are 32
volume levels for both
dial tone and speaker
volume.
The display will show: TONE VOL IIIII II . After 5 seconds, the display will revert to its
previous mode.
Once a call is connected, the speaker volume can be made louder by pressing VOL or softer
by pressing VOL . The display will show SPKR VOL IIIII II . After 5 seconds, the display
will revert to its previous mode.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide
USING THE SOUNDSTATION PREMIER WITH TWO
EXTENDED HYPERCARDIOID MICROPHONES
To place a call:
Press
ON/OFF to turn the SoundStation Premier console on, and dial the number.
USING THE SOUNDSTATION PREMIER
To program and retrieve the conference phone’s phone number
When power is first applied to the phone, the display will read ENTER PHONE # . Type in
the phone number with area code use the * key to enter a space. When finished, press
the
FLASH key.
To retrieve the phone number at any time during a phone call, press SHIFT , then press
the FLASH key. The phone number will be displayed for 10 seconds, then return to its
previous mode.
To adjust the phone’s ringer volume
When the phone is off, press SHIFT , then press VOL or VOL . There are four options:
OFF , LOW , MID , HIGH , and the levels will be heard after each key press. After 5 seconds, the
phone will return to its previous mode.
To use tone dialing or pulse dialing
When the phone is off, press SHIFT , then press REDIAL . The display will read either TONE
DIALING , or if REDIAL is depressed again, PULSE DIALING . The display will return to your
phone number after 5 seconds.
NOTE: Toggle between
TONE or PULSE by
depressing the REDIAL
key only.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide
NOTE: Changing the type of
dialing used when a call is in
progress in only temporary.
NOTE: If caller ID is not
available, there will be no
time of day clock.
NOTE: The volume levels for
dial tone and speaker are
stored independently in the
phone’s memory.