Polycom Wireless Microphone System User Manual
Page 5

To program and use One-Touch dialing
When the phone is off, up to six phone numbers can be stored from the remote keypad.
To program One-Touch dialing phone numbers, press
PROG
. If the SoundStation Premier is
connected to a PBX, press either 8 or 9, then press
PAUSE
(this inserts a two second delay so
the PBX can access an outside line). Next, type in the desired phone number, then press
STORE
, and finally press the desired location to store this phone number, 1-6. On the reverse
side of the remote keypad, there is a place to record these phone numbers.
To use 1-Touch dialing, simply press any of the six stored phone number locations. There is no
need to press
ON/OFF
.
Your Wall Module is equipped with an RCA jack to record a conversation. Plug one end of an
RCA-type connector into the jack on a tape recorder unit labeled
AUX IN
and the other end
into the Wall Module jack labeled
AUX OUT
.
IN CASE OF DIFFICULTY
No dial tone
▼
Check that all connections are correct and tight.
▼
Make sure the short cable is connected to a standard analog telephone line.
▼
Try a different telephone line.
Short silences, echoes, or clipped speech
▼
Don’t move the SoundStation Premier console while it’s in use.
▼
Keep your hands away from the unit during calls.
▼
Keep papers, cups, coffee pots, etc., away from the unit.
▼
At the beginning of a call, let someone at each location speak in turn for a few moments, to
enable SoundStation Premier to adapt to its environment.
▼
The other party may be using lower-quality equipment or a half-duplex conference bridge,
in which case there may be little you can do.
▼
Try calling again to see if another line provides a better connection.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide
To place the call on hold or mute
At any time during a phone call, press
SHIFT
, then press
MUTE
on the main keypad to place a
call on
HOLD
, or simply press
HOLD
on the remote keypad. This shuts off the speaker and all
microphones. The display will show
HOLD
and all LEDs begin blinking red.
To take the phone off
HOLD
press only the
MUTE
key on the main keypad or
HOLD
on the
remote keypad. To shut off the microphones while keeping the speaker on, simply press
MUTE
.
The display will show
MUTE
and the LED’s will turn from green to red. To take the phone off
MUTE
, press
MUTE
on either keypad.
To redial the last phone number called
Press the redial key. The display on the main keypad shows the last phone number which you
have called or attempted to call.
To make a 3-way conference call or to transfer a call to another extension
(if enabled on your telephone system)
Once a call is in progress, press the
FLASH
key.
A second dial tone will be heard and the display will read
FLASH
. To transfer the call, dial the
extension and hang up the phone by pressing
ON/OFF
. To make a 3-way conference call, dial
the second phone number. Once connected, press
FLASH
again, the two other parties will now
be connected.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide
NOTE: The
ON/OFF
key
does not have to be pressed
for
REDIAL
to operate.
NOTE: To hold a conference
call with more than three
parties, a conference call
service provider (such as
Confertech, AT&T, MCI and
Sprint) is required, or contact
your telecom manager.
NOTE: The main keypad does
not enable One-Touch
dialing.
Aux Out
NOTE: If no PBX exists,
PAUSE
is not required.