Precor Elliptical Fitness Crosstrainer EFX - Manual (Page 9)

536i Elliptical Fitness CrossTrainer Assembly Guide 7
CAUTION: Avoid cross-threading. Make sure the moving arm
assembly is well-aligned with the pivot tube before wrench
tightening. Any damage caused during installation is not
covered by the Precor Limited Warranty.
Attach one moving arm assembly at a time. Align and thread it
carefully into the pivot tube. To secure it, use a ½-inch open
end wrench and tighten the moving arm pivot joint. Guide the
moving arm to its equilibrium point and let it rest there.
Perform the same step for the opposite side.
Attach the lower link arms onto the moving handlebars using
two joint connector screws (H), two star washers (K), and two
joint connector nuts (J). Perform this step on one handlebar at
a time. Wrench tighten using a 5mm hex key.
Important: Be aware of the handlebar locations during
assembly. When assembling the lower link arms, position
yourself at the front of the EFX.