PYLE Audio PICD65I User Manual

Page 5

OPERATION WITH THE iPod/ iPhone

- TURN ON BOTH THE UNIT AND THE iPod/ iPhone.
- PRESS THE

KEY REPEATEDLY UNTIL THE DISPLAY SHOWS “iPod”

OR SIMPLY PRESS THE "DOCK" KEY ON REMOTE CONTROL.

- THE UNIT WILL AUTOMATICALLY START PLAYBACK OF THE SONGS.
- THE iPod

DISPLAY WILL INDICATE THE INFORMATION OF THE CURRENT

SONG (TRACK).

/ iPhone

- AT ANYTIME DURING PLAYBACK, PRESS THE

KEY

TO PAUSE OPERATION OF THE UNIT. PRESS

KEY TO RESUME

OPERATION AT THE SAME TRACK & POSITION.

- AT ANYTIME DURING PLAYBACK, PRESS & HOLD THE

KEY

TO STOP PLAYBACK OF UNIT.

- AT ANYTIME DURING PLAYBACK, PRESS AND RELEASE THE

KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE

CONTROL) TO SKIP FORWARD OR BACKWARDS BY ONE TRACK, AS DESIRED.

PLAY/PAUSE

- ANY ANYTIME DURING PLAYBACK, PRESS AND HOLD THE

KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE

CONTROL) TO FAST-FORWARD (CUE) OR FAST-REVERSE (REVIEW)
THE SPECIFIC TRACK, WHICH IS CURRENTLY PLAYING.

- YOU CAN OPERATE THE iPod

USING EITHER THE SET, REMOTE CONTROL

OR DIRECTLY WITH THE iPod

ITSELF.

- WHEN THE iPod

HAS BEEN CONNECTED WITH THE UNIT, IT WILL START

CHARGING THE BATTERY OF THE iPod

/ iPhone

- NEVER REMOVE (OR UNPLUG) THE iPod/ iPhone FROM THE SET DURING PLAYBACK,

ALWAYS PRESS & HOLD FOR 2 SECONDS THE

KEY FIRST AND THEN

PRESS THE

KEY TO SWITCH TO ANOTHER SOURCE (EG. “RADIO”

OR “AUX”) BEFORE REMOVING OR UNPLUGGING THE iPod/ iPhone,
TO PREVENT DAMAGE TO YOUR SONG FILES OR MEMORY DEVICES.

FUNCTION

PLAY/PAUSE

FUNCTION

3D-VIRTUAL SURROUND

REPEAT PLAYBACK FUNCTION (iPod/ iPhone)

- AT ANYTIME DURING iPod/ iPhone PLAYBACK:
- PRESS THE "PLAY MODE" KEY ON REMOTE CONTROL OR

PRESS THE FOLLOWING SYMBOLS ON THE iPod/ iPhone SCREEN:

= TO REPEAT THE CURRENT TRACK

= TO REPEAT ALL TRACKS

THIS UNIT IS DESIGNED TO ALLOW YOU TO CONNECT AN

WITHOUT THE

NEED FOR DOCK CONNECTORS. THE DESIGN OF THE UNIT HAS BEEN STRUCTURED
TO PROVIDE SUPPORT TO TE CONNECTOR UNDER NORMAL USAGE WITHOUT EXCESSIVE
PRESSURE ON THE

WHEN CONTROLLING PLAYBACK USING THE

SCREEN.

iPod/ iPhone

"Made for iPod," "Made for iPhone," mean that an electronic accessory has
been designed to connect specifically to iPod, iPhone, respectively, and has been certified
by the developer to meet Apple performance standards. Apple is not responsible for the operation
of this device or its compliance with safety and regulatory standards. Please note that the use
of this accessory with iPod, iPhone may affect wireless performance.

BACK/ TUNE -

NEXT/ TUNE +

BACK/ TUNE -

NEXT/ TUNE +

E-9

E-10

ELECTRONIC VOLUME CONTROL

- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL

- TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, PRESS

THE VOLUME UP (VOL +) OR VOLUME DOWN (VOL -) KEYS RESPECTIVELY.

- RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS.
- SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU MAY NOTICE

A "CLICK-CLICK-CLICK" (REPEATING) SOUND WHEN YOU ARE INCREASING OR
DECREASING THE VOLUME. THIS IS A NORMAL CONDITION & THE SOUND WILL
DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY (WHEN YOU REACH THE
DESIRED VOLUME LEVEL).

(PUSH BUTTON TYPE)

OPERATION OF RADIO

- PRESS THE "ON/OFF" KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE

KEY (ON UNIT) REPEATEDLY UNTIL THE DISPLAY

SHOWS "FM"

- TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE

AND ADJUST IT'S POSITION.

- USE THE "FM MODE" KEY (ON REMOTE CONTROL) TO SELECT THE

DESIRED MODE (

. IN SOME CASES, WHERE RECEPTION IS

POOR, IT MAY BE ADVISABLE TO SELECT “MONO” MODE, TO IMPROVE CLARITY
OF THE RADIO SIGNAL.

OR PRESS THE "TUNER" KEY ONCE ON REMOTE CONTROL

FM MONO/STEREO)

MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)

- PRESS (AND IMMEDIATELY RELEASE) THE

KEY OR

KEY TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.

- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH

STEP’S POSITION.

- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED

INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

NEXT

BACK

AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)

- PRESS AND HOLD (FOR 2 SECONDS) THE

KEYS

TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
TO THE NEXT AVAILABLE RADIO STATION.

- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE

NEXT STATION THAT IS FOUND.

- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE

“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

NEXT

BACK

FUNCTION

RADIO MEMORY (STATION PRESET MEMORY STORAGE)

- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE

STORED INTO ONE OF THE MEMORY POSITION.

- PRESS

KEY ONCE.

- PRESS

KEY ON THE REMOTE CONTROL TO SELECT

DESIRED MEMORY POSITION. (THERE ARE 30 MEMORY POSITIONS FOR FM BAND).

- PRESS

KEY ONCE TO SAVE THE SELECTED STATION INTO THE

SELECTED MEMORY POSITION.

- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS

THE SAVED RADIO-BAND WILL BE RECALLED.

- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO

THE SAME MEMORY POSITION.

PROGRAM

RADIO M+

PROGRAM

RADIO M-

RADIO M+

RADIO M-